SFL Type Flexographic Printing Machine│Flexo printing machine

Flexographic printing machine SFD-1400-6

Stable register accuracy with center drum improves operability in flexographic printing.

※ Number of printing colors 1-6

Turret center winding available
High precision register accuracy controlled by section drive in the center drum.
Doctor chamber allows high-speed printing without ink splattering.
Constant pressure maintained between center drum, plate cylinde and anilox roll; allowing high quality, mass production.
EB and UV inks
For non-explosive, water-based inks only

Maximum machine speed

300 m/min

Base material

Poly lami paper/ other paper

Use	Water-based center drum flexographic printing machine (also compatible for oil based inks)
Base material	Poly lami paper, paper (plastic film according to conditions)
Base material width	800 - 1,300 mm (depending on request max. about 2,600 mm)
Roll face length	1,400 mm (max. base material width + about 100 mm)
Machine speed	Max. 300 m / min (optional 400 m / min)
Plate cylinder circumference	470 - 800 mm
Unwind/rewind diameter	φ1,200 mm
Register control	Vertical / horizontal automatic sectional drive system
Adjusting contact pressure	Servomotor contact pressure adjustment
Dryer	Overhead dryer
Heat source	LPG gas, steam, electricity, etc.

※ The above specifications are subject to change without notice.
※ The specifications can be flexibly customized according to customer request.

Backsheet flexographic printing press

Model: SFL-2200-2

Ideal for low tension applications of back sheets for disposable diapers.

Maximum machine speed

200 m/min

Base material

Polyethylene, paper

Low tension of backsheet for diaper use
High precion register accuracy by the section drive control in the center drum system
Doctor chamber allows high speed printing without ink splattering
Automatic print pressure between center drum, plate cylinder, and anilox roll with fine servo motor. Allows high quality mass production printing
Supports in-line casting equipment
For water-use only, nonexplosive

Use	Flexographic printing machine for backsheet (aqueous/oil)
Base material	Polyethylene, paper...etc.
Base material width	1,600- 2,100 mm (corresponding to your request max. approx. 2,700 mm)
Roll face length	2,200 mm (max.= base material width + about 100 mm)
Machine speed	Max. 200 m / min (400 m/min possible if drying space can be taken)
Plate cylinder	470 - 800 mm
Register control	Vertical / horizontal automatic sectional drive system
Adjusting contact pressure	Servomotor contact pressure adjustment
Dryer	Single dryer
Heat source	LPG gas, steam, electricity, etc.